Emergi-Lite Tel: (888) 552-6467 Fax: (800) 316-4515 www.emergi-lite.com
03/14 750.1298 Rev. E
1/1
EF41 - Remote Heads
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should
always be followed including the following:
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS.
1. Servicing of this equipment should be performed by qualified
service personnel.
2. Make sure the area is clear of all HAZARDS before installing or
servicing the unit.
3. Turn off electrical power before and during installation and
maintenance.
4. Before conducting maintenance, turn off the unit and wait for it to
cool.
5. Do not install where the marked operating temperatures (T-Code)
exceed the ignition temperature of the hazardous atmosphere.
6. Do not operate in ambient temperatures above those indicated on
the rating labels.
7. Keep tightly closed when in operation.
8. Do not use outdoors.
9. Do not let the power cords touch hot surfaces.
10. Do not mount near gas or electric heaters.
11. Use caution when handling batteries. Battery acid can cause burns
to the skin and eyes. If acid is spilled on the skin or eyes, flush
acid with fresh water and contact a physician immediatly. Avoid
possible shorting.
12. Equipment should be mounted in locations and at heights where it
will not readily be subjected to tampering by unauthorized
personnel.
13. The use of accessory equipment not recommended by the
manufacturer may cause an unsafe condition.
14. Do not use this equipment for other than intended use.
SAVE THESE INSTRUCTIONS
Installation Instructions
1. Turn off power.
2. Remove the lens (3).
3. Install the junction box on the wall or ceiling (9).
4. Install the gasket (8) on to the back plate(7).
5. Connect the lamp wires to the emergency circuit using wire
nuts provided with the unit. For double lamp assembly fixtures,
lamps should be connected in parallel, not in series. Refer to
lamp voltage indicated on the unit.
For 120V units, connect the
ground(green wire).
6. Fasten the back plate to the junction box.
7. Adjust the lamp assemblies:
- Rotation: hold the lamp assembly and turn it to either side.
- Tilting: hold the lamp assembly and tilt it up or down.
8. Before installing the lens, make sure there is no particles on the
gaskets, this can affect sealing. Secure the lens to the back
plate with the screws provided. Make sure the o-rings (4) are
installed between the lens and the back plate, as shown in fig-
ure 1.
ATTENTION: All lens and junction box
screws must be tight-
ened to a torque of 15inlb and
plugs properly sealed with a
sealing compound.
9. Turn on power and check the operation of you lighting fixture.
Lamp replacement
Refer to the relamping label located on the lamp holder for the
recommended voltage and wattage. Do not exceed recommended
voltage or wattage.
WARNING:
Risk of Shock.
Disconnect Power before Installation.
EF41 - Remote Heads
Part List
1. Screw cover (2)
2. Lens screw (2)
3. Lens
4. O-ring (2)
5. Junction box screws (4)
6. Head (1 or 2)
7. Back plate
8. Gasket
9. Junction box (provided with
the unit)
(1 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels