Emergi-lite EFR2 Distinction Series Manuel d'utilisateur télécharger pdf

Emergi-Lite Tel: (888) 552-6467 ext. 547 or 255 Fax: (888) 867-1565 www.emergi-lite.com

05/08 750.0943 Rev. B

Distinction Series - Self-Powered Pot-Lite

1/2

Distinction Series - Self-Powered Pot-Lite

IMPORTANT SAFEGUARDS

When using electrical equipment, basic safety precautions should

always be followed including the following:

READ AND FOLLOW ALL SAFETY

INSTRUCTIONS

1. Do not use outdoors.

2. Do not let power supply cords touch hot surfaces.

3. Do not mount near gas or electric heaters.

4. Use caution when handling batteries. Avoid possible shorting.

5. Equipment should be mounted in locations and at heights where it

will not readily be subjected to tampering by unauthorized personnel.

6. The use of accessory equipment not recommended by the manufac-

turer may cause an unsafe condition.

7. Caution: If optional Halogen cycle lamp(s), symbol (H—), are used in

this equipment, to avoid shattering: do not operate lamp in excess of

rated voltage, protect lamp against abrasion and scratches and

against liquids when lamp is operating, dispose of lamp with care.

8. Halogen cycle lamps operate at high temperatures. Do not store or

place flammable materials near lamp.

9. Do not use this equipment for other than intended use.

10. All servicing should be performed by qualified service personnel.

SAVE THESE INSTRUCTIONS

Installation Instructions

1. Turn off AC power.

2. Carefully unpack the emergency lighting unit. Set the light unit aside

when installing the back box.

3. Remove the junction box cover by releasing the spring. Break the

appropriate knockout for AC supply on the back box (see fig. 2).

Choose the proper mounting solution: new sheet rock construction or

suspended ceiling. Follow the proper mounting section and continue the

installation at step 4.

New sheet rock construction

a. Slide the hanger bars through the tabs on the back box. For each

side, first slide the bar that has two small arrows at its end facing

outside the box. Then slide the one with a long slot on top of the

first one. The two arrows should go through the long slot on the

second bar. Place the assembly between the framing members.

Align the open round surface of the box where the finished sur-

face of sheet rock will be and nail bars to the framing members

(see fig. 3).

Figure 1

Part List

1. Back box

2. Hanger bars

3. Hanger bar nail

4. Junction box cover

5. Light unit

6. Self-drilling screw (3)

7. Suspended ceiling clip (4)

Knockout holes

Figure 2

Pull out to open

box cover

the junction

Figure 3

Tabs

First hanger bar

to slide

Second hanger

bar to slide

Small arrows

go through the

slot on the

second bar

1 2

Résumé du contenu

Page 1 - SAVE THESE INSTRUCTIONS

Emergi-Lite Tel: (888) 552-6467 ext. 547 or 255 Fax: (888) 867-1565 www.emergi-lite.com05/08 750.0943 Rev. BDistinction Series - Self-Powered Pot-Lite

Page 2 - 05/08 750.0943 Rev. B

Distinction Series - Self-Powered Pot-LiteEmergi-Lite Tel: (888) 552-6467 ext. 547 or 255 Fax: (888) 867-1565 www.emergi-lite.com05/08 750.0943 Rev. B

Commentaires sur ces manuels

Pas de commentaire

Emergi-lite EFR2 Distinction Series Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Fournisseurs d'énergie Emergi-lite EFR2 Distinction Series. Emergi-Lite EFR2 Distinction Series User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Fournisseurs d'énergie Emergi-lite EFR2 Distinction Series