Emergi-lite Survive-All SVXH Series Manuel d'utilisateur télécharger pdf

Emergi-Lite Tel: (888) 552-6467 Fax: (800) 316-4515 www.emergi-lite.com

12/08 750.1377 Rev. B

1/2

SVXH Series – Class I, Div 2 Combo Unit

Installation instructions

IMPORTANT SAFEGUARDS

When using electrical equipment, basic safety precautions should always be

followed including the following:

READ AND FOLLOW ALL SAFETY

INSTRUCTIONS

1. Make sure the area is NON-HAZARDOUS before installing or servic-

ing the unit.

2. Turn off electrical power before and during installation and mainte-

nance.

3. Before opening, turn off electrical power and wait until the unit is cool.

4. Do not install where the marked operating temperatures (T-Code)

exceed the ignition temperature of the hazardous atmosphere.

5. Do not operate in ambient temperatures above those indicated on

the rating labels.

6. Keep tightly closed when in operation.

7. Do not use outdoors.

8. Do not mount near gas or electric heaters.

9. Use caution when handling batteries. Battery acid can cause burns to

the skin and eyes. If acid is spilled on the skin or eyes, flush acid

with fresh water and contact a physician immediatly. Avoid possible

shorting.

10. Equipment should be mounted in locations and at heights where it

will not readily be subjected to tampering by unauthorized personnel.

11. The use of accessory equipment not recommended by the manufac-

turer may cause an unsafe condition.

12. Do not use this equipment for other than intended use.

13. Servicing of this equipment should be performed by qualified service

personnel.

SAVE THESE INSTRUCTIONS

Installation Instructions

1. Turn off unswitched AC power.

a. Remove the lens-legend (3). Disconnect the lamps from terminal

block (see fig 4) and remove the electronic module (3). Four screws

secure the electronic module to the housing.

b. Determine which holes in the housing will be used for AC wires. Sup-

port frame by two blocks of wood, maximum one inch apart. Strike

knockouts with a hammer and screwdriver. Clear holes of burrs to

allow proper installation of the fitting. Install conduit fitting rated for

Class I Div 2, on the housing. For Nexus option, install the liquid

tight fitting, provided with the unit to route the data cable.

Conduit Entry

a. Install the unit on the wall with 4 screws (not provided). Use the ears

located on each side (see figure 2).

Figure 1

Part List

1. Tamper-proof screw

2. Screw covers

3. Lens-legend

4. EXIT panel

5. Diffuser panel

6. Frame

7. Electronic module

8. Electronic module screws

(4)

9. Back plate

10. Swivel

11. MR16 lamp

12. O-ring

13. Lens-emergency light

14. Knock-out covers

15. Junction box

Figure 2

Conduit

Fitting

k’out

ears

1 2

Résumé du contenu

Page 1 - SAVE THESE INSTRUCTIONS

Emergi-Lite Tel: (888) 552-6467 Fax: (800) 316-4515 www.emergi-lite.com12/08 750.1377 Rev. B1/2SVXH Series – Class I, Div 2 Combo UnitSVXH Series – C

Page 2 - 12/08 750.1377 Rev. B

SVXH Series – Class I, Div 2 Combo Unit2/2Emergi-Lite Tel: (888) 552-6467 Fax: (800) 316-4515 www.emergi-lite.com12/08 750.1377 Rev. Bb. Route unswit

Commentaires sur ces manuels

Pas de commentaire

Emergi-lite Survive-All SVXH Series Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Fournisseurs d'énergie Emergi-lite Survive-All SVXH Series. Emergi-Lite Survive-All SVXH Series User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Fournisseurs d'énergie Emergi-lite Survive-All SVXH Series