Emergi-lite Survive-All EF40 Series Manuel d'utilisateur télécharger pdf

Emergi-Lite Tel: (888) 552-6467 Fax: (800) 316-4515 www.emergi-lite.com

03/14 750.1205 Rev. D

EF39 Nema-4X Die-cast remote heads

1/1

EF39 Nema-4X Die-cast remote heads

IMPORTANT SAFEGUARDS

When using electrical equipment, basic safety precautions should always be

followed including the following:

READ AND FOLLOW ALL SAFETY

INSTRUCTIONS

1. All servicing should be performed by qualified service personnel.

2. Do not mount near gas or electric heaters.

3. Equipment should be mounted in locations and at heights where it

will not readily be subjected to tampering by unauthorized personnel.

4. The use of accessory equipment not recommended by the manufac-

turer may cause an unsafe condition.

5. Do not use this equipment for other than intended use.

SAVE THESE INSTRUCTIONS

Installation instructions

1. Turn off power.

2. Remove the lens.

3. Install the gasket (8) on the back plate.

4. Connect the lamp wires to the emergency circuit using wire nuts. For

double lamp assembly fixtures, lamps should be connected in parallel,

not in series. Refer to lamp voltage indicated on the unit.

5. Fasten the back plate with 4 screws to either a nema 4X rated junction

box or directly to a recessed junction box making sure the unit is

properly sealed all around (gasket will not guarantee an adequate seal

on all surfaces).

IMPORTANT: The junction box must be Nema 4X rated for the unit to

retain a Nema 4X rating. Plugs must be properly sealed with a sealing

compound.

6. Adjust the lamp assemblies:

- Rotation: hold the lamp assembly and turn it to either side.

- Tilting: hold the lamp assembly and tilt it up or down.

7. Secure the lens to the back plate with the screws provided.

ATTENTION: All lens and junction box screws must be tightened to a

torque of 15inlb.

The screw covers can be installed to prevent the accumulation of

debris on the screws, as required by NSF.

8. Turn on power and check the operation of your lighting fixture.

Lamps replacement

Refer to the relamping label located near the lamp holder or the

recommended maximum wattage. Do not exceed recommended wattage.

Parts List

1. Screw cover (2)

2. Lens screw (2)

3. Lens

4. O-ring (2)

5. Junction box screw (4

required) (not provided)

6. Lamp assembly (1 or 2)

7. Back plate

8. Gasket

9. Weather proof junction

box (not provided).

WARNING:

Risk of Shock.

Disconnect Power before Installation.

Figure 1

Résumé du contenu

Page 1 - SAVE THESE INSTRUCTIONS

Emergi-Lite Tel: (888) 552-6467 Fax: (800) 316-4515 www.emergi-lite.com03/14 750.1205 Rev. DEF39 Nema-4X Die-cast remote heads1/1EF39 Nema-4X Die-cas

Commentaires sur ces manuels

Pas de commentaire

Emergi-lite Survive-All EF40 Series Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Fournisseurs d'énergie Emergi-lite Survive-All EF40 Series. Emergi-Lite Survive-All EF40 Series User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Fournisseurs d'énergie Emergi-lite Survive-All EF40 Series