Emergi-lite ELX Series Manuel d'utilisateur télécharger pdf

AC & Self-Powered LED Exit Signs Installation Instruction

BACK MOUNTING - DIAG. 1

IMPORTANT SAFEGUARDS

When using electrical equipment, basic safety precautions should

always be followed including the following:

READ AND FOLLOW ALL SAFETY

INSTRUCTIONS

2. Do not use outdoors.

3. Do not mount near gas or electric heaters.

4. Do not let power cords touch hot surfaces.

5. Use caution when servicing batteries. Avoid possible shorting.

6. Equipment should be mounted in locations and at heights where

it will not readily be subjected to tampering by unauthorized

personnel.

7. The use of accessory equipment not recommended by the

manufacturer may cause an unsafe condition.

8. Do not use this equipment for other than intended use.

9. Before wiring to AC service, turn off AC power at fuse or circuit

breaker.

10. Disconnect AC power and unplug battery before servicing.

11. When relamping, only use lamps specified in the fixture.

12. Battery in this unit may not be fully charged. After the AC service

is supplied to unit, let the battery charge up for at least 24 hours

before performing any tests.

SAVE THESE INSTRUCTIONS

INSTALLAT

ION

BACK MOUNTING - See diagram 1

1. Drill 1/4" holes into oblong knock outs on back plate (3) that

correspond to junction box (10) holes to be used.

2. Feed the transformer input leads through center hole and make the

proper connections. If using 120VAC, connect the black and white

leads to the building utility. If using 347VAC , connect the red

and white leads to the building utility. Cap off unused wire. If the

unit is self-powered, be sure to snap battery connector together.

3. Feed excess wire into junction box and secure back plate (3) to

junction box (10).

4. Snap in arrows (5) on EXIT panel (2) as required. Then snap EXIT

panel (2) to housing, top first and then bottom.

SIDE MOUNTING - DIAG. 2

CEILING MOUNTING - DIAG. 3

120VAC

INPUT

347VAC

INPUT

BLACK

RED

WHITE

WIRING

1) Plastic housing

2) EXIT panel

3) Back plate

4) Mounting hole cover

5) Snap in directional arrow

6) Red or green diffuser

7) Canopy

8) Canopy screws

9) Wire nuts

10) Junction box (building utility)

11) Crossbar

12) Crossbar screws (not provided)

PARTS DESCRIPTION

INSTALLATION INSTRUCTIONS (1

)

Page 1

1 2

INSTALLATION INSTRUCTIONS ( 2

Résumé du contenu

Page 1

AC & Self-Powered LED Exit Signs Installation InstructionsBACK MOUNTING - DIAG. 1IMPORTANT SAFEGUARDSWhen using electrical equipment, basic safety

Page 2 - INSTALLATION INSTRUCTIONS (

SIDE MOUNTING - See diagram 21. Attach crossbar (11) to junction box (10). Set the crossbar so that the longer blade is touching the junction bo

Commentaires sur ces manuels

Pas de commentaire

Emergi-lite ELX Series Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Fournisseurs d'énergie Emergi-lite ELX Series. Emergi-Lite ELX Series User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Fournisseurs d'énergie Emergi-lite ELX Series